LED SNOWBOARD SYSTEM

You can buy a light strip anywhere. What you can't buy off a shelf is a strip that survives a season of edge impacts, sub-zero temperatures and wet snow while staying stuck to a flexing board.

pinepeak is a complete system, not a length of tape. The strips, housings and adhesive are chosen for one job: staying put and staying lit while you ride.

Clean the topsheet with the included wipe, peel the backing liner and press each strip down along the edge. No screws, no drilling, nothing permanent.

Written instructions and a step-by-step video are included in the box. Most riders are done in under five minutes.

Yes. pinepeak carries an IP68 rating, so wet snow, slush and a night in a cold car are all non-issues.

The strips are fully encapsulated in silicone rather than left exposed, which is what lets them take repeated impacts and keep working season after season.

There are seven colors to cycle through: cyan, blue, green, magenta, red, amber and cool white.

You also get three brightness levels. Turn it up when you want to be seen, turn it down when you want the batteries to last the whole session.

Any board, any brand, any size. There is nothing to measure and nothing model-specific about the fit.

If your board is on the shorter side, the strips can be trimmed for a clean finish.

Each strip runs off its own sealed battery housing. You can use the pinepeak rechargeable lithium cells or a standard 9V battery, whichever suits you.

The rechargeables give around six hours of continuous light and top up over USB-C. A standard 9V runs closer to ten hours before it needs swapping. We recommend the rechargeables for regular night riders.

Yes. The adhesive is built to hold through a full season and then release cleanly when you want it off.

Follow the removal guide included with your kit and your topsheet comes out exactly as it went in.